1-4E
DSC-S40
1-6. PROCESS AFTER FIXING FLASH ERROR
When “FLASH error” (Self-diagnosis Code E : 91 : ** ) occurs, to prevent any abnormal situation caused by high voltage, setting of the
flash is changed automatically to disabling charge and flash setting.
After fixing, this setting needs to be deactivated. Flash error code can be initialized by the operations on the Setup screen.
Method for Initializing the Flash Error Code
Initializes the setting to the default setting.
1
Select [OK] with
v
on the control button, then press
z
.
The message “Initialize all settings Ready?” appears.
2
Select [OK] with
v
, then press
z
.
The settings are reset to the default setting.
•
Make sure that the power is not disconnected during resetting.
Initialize
OK
See the following procedure.
Cancel
Cancels the resetting.
Содержание DSC-S40 - Cyber-shot Digital Still Camera
Страница 24: ...DSC S40 Schematic diagrams of the CH 169 and SY 116 boards are not shown Pages from 4 9 to 4 26 are not shown ...
Страница 30: ...Printed wiring boards of the CH 169 and SY 116 boards are not shown Pages from 4 37 to 4 40 are not shown ...
Страница 35: ...DSC S40 Waveforms of the SY 116 board are not shown Page 4 49 is not shown ...
Страница 36: ...DSC S40 Mounted parts location of the SY 116 board is not shown Page 4 50 is not shown ...