![background image](http://html.mh-extra.com/html/sony/dhc-md313-system-rack/dhc-md313-system-rack_operating-instructions-manual_420512054.webp)
54
•Connect the sound source properly.
•A pre-recorded MD is in the deck.
Replace the disc with a recordable MD.
•Replace the disc with a recordable MD
that has sufficient time remaining or erase
unnecessary tracks.
•The mains lead was unplugged or a
power interruption occurred during
recording. Start recording over from the
beginning.
“END” is displayed.
•You have reached the end of the MD.
Press MD
=
to return to the beginning
of the MD.
“Level Over” appears during analogue
recording.
A strong signal was input during
recording in the TAPE function. When
the sound is distorted, reduce the
recording level, then re-record. If
distortion may occurs:
1 Stop play or turn off the power of the
other component connected to the TAPE
input.
“Level Over” disappear.
2 Press EDIT on the remote during
recording or pause.
3 Press +/– on the remote.
“Attenuate ?” appears.
4 Press ENTER/YES on the remote.
“Attenuate ON ?” appears.
5 Press ENTER/YES again.
“ATT” appears.
6 Turn on the power of the other
component connected to the TAPE input
and continue recording or start recording
over from the beginning.
To cancel the setting, select “Attenuate
OFF ?” in step 4.
Tuner
Severe hum or noise (“TUNED” or
“STEREO” flashes in the display.).
•Adjust the aerial.
•The signal strength is too weak. Connect
an external aerial.
•Make sure the aerial is connected
properly.
•You cannot fold or roll up the aerial.
•The FM aerial is split in two.
Repair or replace with a new one.
•The AM aerial is detached from the stand.
CD Player
The CD tray does not close.
•The CD is not placed properly.
The CD will not eject.
• The CD has tape, seals, or paste on it.
The CD will not play.
•Press CD
§
to check the CD placed.
When you listening to the radio and the
disc tray is open, the CD indicator is lit
red, then the CD is not placed.
•The CD is dirty. Clean the CD with a
cleaning cloth.
•The face of the CD is scratched. Exchange
the CD.
•The CD is inserted label side down.
•Moisture condensation has built up.
Remove the CD and leave the system
turned on for about 2 hours until the
moisture evaporates.
Play does not start from the first track.
•The player is in programme or shuffle
mode. Press PLAY MODE repeatedly
until “SHUFFLE” or “PGM” disappears.
“OVER” is displayed.
•You have reached the end of the CD.
Press CD
=
to return to the beginning
of the CD.
MD Deck
The controls do not work.
•The MD is dirty or scratched. (“Disc
Error” appears.) Replace the MD with a
new one.
The MD will not play.
•Moisture condensation has built up.
Remove the MD and leave the system
turned on for several hours until the
moisture evaporates.
•Insert the MD in the direction of the
arrow.
•Nothing is recorded on the MD.
Recording is not possible.
•The MD is protected against erasure.
(“MD Protected” appears.) Slide the tab
to close the slot (see page 28).
Troubleshooting (continued)