Sony DCR-HC41, Руководство по обслуживанию

Страница: 112 / 216

6-30
DCR-HC39E/HC41/HC42/HC42E/HC43/HC43E
10. MAX GAIN Adjustment
RadarW RadarW RadarW RadarW RadarW
Setting the minimum illumination.
If it is not consistent, the image level required for taking subjects
in low illuminance will not be produced (dark).
Subject Clear chart (Center frame)
Adjustment Page F
Adjustment Address 2C
Note 1:
Perform “Flange Back and Zoom Lever Center Adjust-
ment” before this adjustment.
Note 2: Check that the data of page: 0, address: 10 is “00”.
Note 3: Check that the data of page: 6, address: 02 is “00”. If
not, select page: 6, address: 01, set data: 00, and press
PAUSE button.
Note 4:
NTSC model: DCR-HC41/HC42/HC43
PAL model: DCR-HC39E/HC42E/HC43E
Note 5: If the pattern box (PTB-450) is used, the stability of
brightness is reduced, and thus the adjustment value will
be shifted a little.
The use of small pattern box (PTB-1450) is recom-
mended.
Switch setting
1) POWER ............................................. CAMERA-TAPE mode
2) NIGHTSHOT PLUS ........................................................ OFF
3) ZOOM .................................................................... WIDE end
4) DIGITAL ZOOM (Menu setting) .................................... OFF
5) STEADY SHOT (Menu setting) ..................................... OFF
6) FOCUS (Menu setting) .......................................... MANUAL
7) WIDE SELECT ................................................................ 4: 3
Adjusting method:
Order Page Address Data Procedure
1
Check that the picture frame
is “Center Frame”. If not,
perform “8. Picture Frame
Setting (Center Frame)”
2 0 01 01
3 6 D0
Set the following data.
24: NTSC model
21: PAL model
4 6 D1 00
5 6 01 6F Press PAUSE button. (Note 6)
6 6 02
Check the data changes to
“01”.
Note 6: The adjustment data will be automatically input to page:
F, address: 2C.
Processing after Completing Adjustment:
Order Page Address Data Procedure
1 6 01 00 Press PAUSE button.
2 0 01 00
11. Mechanical Shutter Adjustment
RadarW RadarW RadarW
Adjustment Page F
Adjustment Address 76 to 8B
Note 1:
Check that the data of page: 0, address: 10 is “00”.
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Input the following data to page: F, address: 76 to 8B.
Note:
Press the PAUSE button of the adjustment remote com-
mander each time to set data.
Address Data
76 50
77 93
78 3D
79 8D
7A 35
7B 99
7C 31
7D 83
7E 2D
7F 7B
80 60
81 73
82 77
83 72
84 60
85 1C
86 80
87 80
88 80
89 80
8A 80
8B 82
3) Select page: 0, address: 01, and set data: 00.