Getting Started
27
Height diagram
• R. H. LOW
Select this if the rear speakers are located in section
D
.
• R. H. HIGH
Select this if the rear speakers are located in section
C
.
These parameters are not available when “REAR” is set to “NO”.
To specify the balance and level of the speakers
1
Press AMP MENU repeatedly to display
9
LEVEL on the front panel display.
2
Using
X
/
x
to select T.TONE and use
C
/
c
to set T.TONE to ON.
You will hear the test tone from each speaker in sequence.
3
Sit in your listening position and select the item to be adjusted using
X
/
x
.
• Items adjusted in
9
LEVEL
– Balance of the front and rear speakers
– Volume level of the centre and rear speakers and subwoofer
4
Adjust the volume level so that the volume of the test tone from each speaker sounds the
same using
C
/
c
.
The adjusted value will appear on the front panel display.
5
Repeat Steps 3 and 4 to adjust other parameters in
9
LEVEL.
If you do not operate the remote for a few seconds, the value disappears from the display
and is stored in the system.
6
Using
X
/
x
to select T.TONE and use
C
/
c
to set T.TONE to OFF.
x
BALANCE
You can vary the balance of each speaker as follows. The default adjustments are in the
parentheses.
• F ___I___ (centre) (front speakers)
Adjust the balance between the front left and right speakers (You can adjust from centre,
6 steps left or right).
• R ___I___ (centre) (rear speakers)
Adjust the balance between the rear left and right speakers (You can adjust from centre,
6 steps left or right).
60
30
C
C
D
D
continued
