Sony DAV-DZ7T, Руководство по эксплуатации

Страница: 75 / 112

A
d
v
a
n
ced
Settin
g
s a
nd A
d
justm
e
nt
s
75
GB
Connect the calibration mic to the A.CAL
MIC jack on the front panel, and set it up at
the ear level using a tripod, etc. (not
supplied). The front of each speaker should
face the calibration mic, and there should be
no obstruction between the speakers and the
calibration mic. Be quiet during the
measurement.
5
Press X / x to select [YES], then press
.
Calibration starts.
Note
• The image in the illustration above is different
from the actual system.
• Avoid being in the measurement area and
making noise during the measurement (about
one minute), to avoid measurement failure.
During the measurement, test signals are output
from the speakers.
• The environment of the room in which the
system is installed may affect measurements.
• If an error message appears, follow the message,
then select [YES].
An error message appears when:
– the calibration mic is not connected.
– front speakers are not correctly connected.
– surround speakers are not correctly
connected.
– front and surround speakers are not correctly
connected.
– subwoofers are not connected.
• For [FRONT L], [FRONT R], or
[SUBWOOFER], the system calibrates all the
speakers, but only the measurement of the
nearer speaker is displayed.
6
Press C / X / x / c to select [YES] or [NO],
then press .
x The measurement is OK.
Disconnect the calibration mic, then select
[YES]. The result is implemented.
x The measurement is not OK.
Follow the message, then select [YES] to
retry.
AUDIO IN / MIC 1 /
A.CAL MIC
Calibration mic
Measuring. Please wait a moment.
FRONT L :
FRONT R :
CENTER :
SUBWOOFER :
SURROUND L :
SURROUND R :
If OK, unplug calibration mic and select
“YES”.
YES
5.00m 0.0dB
5.00m 0.0dB
5.00m + 1.0dB
5.00m + 4.0dB
3.00m - 2.0dB
3.00m - 2.0dB
Measurement complete.
NO
Check speaker connection.
Retry?
YES
Measurement failure.
NO
continued