Sony CMT-X7CD, Руководство по эксплуатации, Страница: 36 / 56

36 GB
Play does not start.

Turn off the system and reconnect the USB
device, then turn on the system.

An incompatible USB device may be
connected.
Play does not start from the first track.

Set the play mode to “NORMAL” play mode.
The USB device cannot be charged.

Make sure the USB device is connected
securely to the
(USB) port.

The USB device may not be supported by this
system.

Disconnect the USB device and then reconnect
it. For details on the charging status of the
USB device, see the operating manual of the
USB device.
Severe hum or noise occurs (“STEREO”
flashes in the display window), or
broadcasts cannot be received.

Connect the antenna properly.

Find a location and an orientation that provide
good reception, and then set up the antenna
again.

Keep the antennas away from the unit or
other AV components to avoid picking up
noise.

Turn off nearby electrical equipment.
Several radio stations can be heard at the
same time.

Find a location and an orientation that provide
good reception, and then set up the antenna
again.

Bundle the antenna cables using
commercially available cord clips and adjust
the cable lengths.
DAB/DAB+ radio station is not received
properly.

Check all antenna connections, then perform
the DAB Automatic Scan procedure. See
“Running the DAB Automatic Scan manually
(CMT-X7CDB only)” (page 14).

The current DAB/DAB+ service may not be
available.
Press /– to select a different service.

If you have moved to another area, some
services/frequencies may have changed and
you may not be able to tune into your usual
broadcast. Perform the DAB Automatic Scan
procedure to re-register the contents of
broadcasts. (Performing this procedure clears
all previously stored presets.)
The DAB/DAB+ broadcast has been
interrupted.

Check the location of the system or adjust the
orientation of the antenna to increase the
indicated value of the signal quality.
The system cannot connect to the network.
(Other equipment on the network cannot
find or recognize the system.)

Check that is lit in the display window.

It takes about 1 minute for the system to
acquire an IP address when the system is
turned on in a communication environment
without a router.

When you use a fixed IP address, the same IP
address may be used by other equipment. Use
a different IP address.
The system cannot connect to the network
via a wireless LAN connection.

If a network (LAN) cable is connected to the
system, the system automatically operates to
establish a wired LAN connection. If you wish
to use a wireless LAN connection, do not
connect a network (LAN) cable to the system.

Check the settings of the wireless LAN router/
access point. If the SSID stealth mode is set to
“ON” on the access point, set it to “OFF.” For
details on the settings of the access point of
the wireless router, refer to the operating
manual for the access point.
The system cannot connect to the network
using WPS.

Set up your network after searching the access
point using the access point scan.

You cannot connect to a network using WPS
when your access point is set to WEP.

Update the firmware of the wireless LAN
router/access point to the latest version.
Tuner
Network connection