Sony CMT-EX5 - Micro Hi Fi Component System, Руководство по обслуживанию

Страница: 4 / 66

2
HCD-EX5
After correcting the original service problem, perform the
following safety checks before releasing the set to the customer:
Check the antenna terminals, metal trim, “metallized” knobs, screws,
and all other exposed metal parts for AC leakage. Check leakage as
described below.
LEAKAGE
The AC leakage from any exposed metal part to earth ground and
from all exposed metal parts to any exposed metal part having a
return to chassis, must not exceed 0.5 mA (500 microamperes).
Leakage current can be measured by any one of three methods.
1. A commercial leakage tester, such as the Simpson 229 or RCA
WT-540A. Follow the manufacturers’ instructions to use these
instruments.
2. A battery-operated AC milliammeter. The Data Precision 245
digital multimeter is suitable for this job.
3. Measuring the voltage drop across a resistor by means of a
VOM or battery-operated AC voltmeter. The “limit” indication
is 0.75 V, so analog meters must have an accurate low-voltage
scale. The Simpson 250 and Sanwa SH-63Trd are examples of
a passive VOM that is suitable. Nearly all battery operated
digital multimeters that have a 2V AC range are suitable. (See
Fig. A)
SAFETY CHECK-OUT
To Exposed Metal
Parts on Set
0.15
µ
F
1.5 k
Ω
AC
Voltmeter
(0.75 V)
Earth Ground
Fig. A. Using an AC voltmeter to check AC leakage.
General
Power requirements
North American model:
120 V AC, 60 Hz
European model: 230 V AC, 50/60 Hz
Mexican model: 120 V AC, 60 Hz
Australian model: 220 – 240 V AC,
50/60 Hz
Korean model: 220 V AC, 60 Hz
Chinese model: 220 V AC, 50/60 Hz
Other models: 110 – 240 V AC,
50/60 Hz
Power consumption
European model:
See the nameplate
0.25 W (at the Power
Saving Mode)
Other models: See the nameplate
Dimensions (w/h/d) Approx. 186
×
235
×
157 mm incl. projecting
parts and controls
Mass Approx. 3.0 kg
Design and specifications are subject to change
without notice.