18
Recording a CD on an MD (continued)
Recording a tape on an
MD
— TAPE-MD Synchro Recording
You can make an analogue recording of a tape
on an MD.
1
Load a recordable MD.
2
Insert a tape.
3
Press SYNCHRO MODE repeatedly until
“TAPE
t
MD SYNC?” appears.
4
Press ENTER/START.
The MD deck stands by for recording and
the tape deck pauses for play.
Tape playback side
>>>
appears for the top side, and
<<<
for
the bottom side. To play the side not
indicated, press
x
and remove the cassette
to reverse the tape side, then perform steps
3 and 4 again.
5
Press ENTER/START again.
Recording starts.
To stop recording
Press
x
.
Note
If the MD becomes full during recording, the tape
deck and the MD deck stop automatically.
If “Retry” flashes in the display after
you press ENTER/START in step 7
A reading failure has occurred, and the system
is trying to read the data again.
• If the retry was successful, the system
continues with High-Speed CD-MD Synchro
Recording.
• If the condition of the inserted CD or the
system is poor, and retry fails, High-Speed
CD-MD Synchro Recording is disabled. In
this case, “
×
1” flashes in the display and the
MD deck automatically starts recording.
Note that monitoring of the recorded signal
is not possible when this occurs.
To record on an MD for a long time
(MDLP recording)
See “Recording tips” on page 20.
To stop recording
Press
x
.
Tips
• Depending on the disc, CD TEXT information may
also be recorded (except when you record on an
MD and a tape at the same time). If “CD-TEXT”
flashes during recording, see “Labelling an MD” on
page 25.
• You can record only your favourite CD tracks with
Programme Play. After step 2, follow the same
procedures as step 1 to 6 in “Programming CD
tracks” on page 11. Then, go to step 5.
Notes
• You cannot pause recording during High-Speed
CD-MD Synchro Recording.
• If the play mode is set to Repeat Play or Shuffle
Play, it automatically switches to normal play at
step 6.
• The following items are either inoperative or cannot
be used during High-Speed CD-MD Synchro
Recording:
— The Auto Cut Function
— The recording level specified in the Setup menu
• If the MD becomes full during recording, the CD
player and the MD deck stop automatically.