28
Error displays/Messages
Radio reception
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
• Connect a power antenna control lead (blue)
or accessory power supply lead (red) to the
power supply lead of a car’s antenna booster
(only when your car has built-in FM/AM
antenna in the rear/side glass).
• Check the connection of the car antenna.
• The auto antenna will not go up.
t
Check the connection of the power
antenna control lead.
• Check the frequency.
• When the DSO mode is on, the sound is
sometimes hampered by noises.
t
Set the DSO mode to “OFF” (page 23).
Automatic tuning is not possible.
• The local seek mode is set to “ON.”
t
Set the local seek mode to “OFF”
(page 21).
• The broadcast signal is too weak.
t
Perform manual tuning.
The “STEREO” indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t
Set the monaural reception mode to
“ON” (page 21).
A program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
t
Cancel monaural reception mode
(page 21).
Interference occurs during FM reception.
The wide mode is selected.
t
Set the IF mode to “IF AUTO” (page 21).
Error displays
(For this unit and optional CD/MD changers)
The following indications will flash for about
5 seconds, and an alarm sound will be heard.
BLANK
*
1
No tracks have been recorded on an MD.*
2
t
Play an MD with recorded tracks on it.
ERROR
*
1
• A CD is dirty or inserted upside down.*
2
t
Clean or insert the CD correctly.
• A CD/MD cannot play because of some
problem.
t
Insert another CD/MD.
FAILURE
(Illuminates until any button is
pressed.)
The connection of speakers/amplifiers is
incorrect.
t
See the installation guide manual of this
model to check the connection.
FAILURE
(Illuminates for about 1 second.)
When the XM tuner is connected, storing an
XM radio channel into a preset failed.
t
Be sure to receive the channel that you
want to store, then try it again.
HI TEMP
The ambient temperature is more than 50°C
(122°F).
t
Wait until the temperature goes down
below 50°C (122°F).
NO DISC
No disc is inserted in the CD/MD unit.
t
Insert discs in the CD/MD unit.
NO MAG
The disc magazine is not inserted in the CD
unit.
t
Insert the magazine in the CD unit.
