Additional Information
18
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There’s no sound.
/
Check that the player is connected securely.
/
Make sure you operate the amplifier correctly.
/
Adjust the playback level using the LINE OUT
LEVEL +/– buttons on the remote (CDP-CE335
only).
The CD does not play.
/
There’s no CD inside the player (“no dISC”
appears). Insert a CD.
/
Place the CD with the label side up on the disc
tray correctly.
/
Clean the CD (see page 17).
/
Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 17).
/
Place the CD in the correct position on the disc
tray.
The remote does not function. (CDP-CE335 only)
/
Remove the obstacles in the path of the remote
and the player.
/
Point the remote at the remote sensor
g
on the
player.
/
Replace all the batteries in the remote with new
ones if they are weak.
The player functions incorrectly.
/
The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
Specifications
Compact disc player
Laser
Semiconductor laser (
λ
= 780 nm)
Emission duration: continuous
Laser output
Max 44.6
µ
W*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response
2 Hz to 20 kHz ± 0.5 dB
Signal-to-noise ratio
More than 102 dB
Dynamic range
More than 98 dB
Harmonic distortion
Less than 0.0045%
Output
LINE OUT
DIGITAL OUT
(OPTICAL)
Jack
type
Phono
jacks
Optical
output
connector
Maximum
output
level
2 V
(at 50 kilohms)
–18dBm
Load
impedance
Over 10 kilohms
Wave length: 660nm
General
Power requirements
Power consumption
14 W
Dimensions (approx.)
430
×
120
×
385 mm
(w/h/d)
(17
×
4 3/4
×
15 1/4 in.) incl. projecting
parts
Mass (approx.)
5.4 kg (11 lbs 15 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (1) (CDP-CE335 only)
R6 (size AA) batteries (2) (CDP-CE335 only)
Design and specifications are subject to change without notice.
Where purchased
USA
Australia
Power requirements
120 V AC, 60 Hz
240 V AC, 50/60 Hz