Sony CCD-TRV65E, CCD-TRV3E, CCD-TRV15E, CCD-TRV23E, CCD-TRV35E, Руководство по обслуживанию

Страница: 94 / 188

5-8
1-2. INITIALIZATION OF D, E, F PAGE DATA
1. Initializing the D,E,F Page Data
Note 1: If “Initializing the D, E, F Page Data” is performed,
all data of the D page, E page and F page will be
initialized. (It is impossible to initialize a single
page.)
Note 2: If the D,E,F page data has been initialized, “Modification
of D, E, F Page Data” and all adjustments need to be
performed again.
Note 3: < > : NTSC model (CCD-TRV75/TRV75PK/TRV715)
[ ] : PAL model (CCD-TRV3E/TRV13E/TRV23E/
TRV45E/TRV55E/TRV65E/TRV69E)
Initializing Method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 2, address: 00, and set data: 55 <NTSC> or
data : 51 [PAL].
3) Select page: 2, address: 01, set data: 55<NTSC> or data : 51
[PAL], and press the PAUSE button of the adjusting remote
commander.
4) Select page: 2, address: 02, and check that the data is 01.
5) Select page: 3, address: 00, and set data: 29.
6) Select page: 3, address: 01, set data: 29, and press the PAUSE
button of the adjusting remote commander.
7) Select page: 0, address: 01, and set data: 00.
8) Perform “Modification of D,E,F Page Data”.
Adjusting page D
Adjusting Address 00 to 6F
Adjusting page F
Adjusting Address 00 to FF
Adjusting page E
Adjusting Address 00 to FF
2. Modification of D, E, F Page Data
If the D, E, F page data has been initialized, change the data of the
“Fixed data-2” address shown in the following tables by manual
input.
Modifying Method:
1) Before changing the data, select page: 0, address: 01, and set
data: 01.
2) New data for changing are not shown in the tables because they
are different in destination. When changing the data, copy the
data built in the same model.
Note :
If copy the data built in the different model, the camcorder
may not operate.
3) When changing the data, press the PAUSE button of the adjusting
remote commander each time when setting new data to write the
data in the non-volatile memory.
4) Check that the data of adjustment addresses is the initial value.
If not, change the data to the inital value.
5) After compleating “Modification of D, E, F Paga Data” select
page: 0, address: 01, and set data: 00. Also perform all
adjustments.