Sony BRAVIA 55A1, Справочное руководство

Страница: 3 / 116

3 GB
GB
If your existing television set is being retained and relocated, the
same considerations as above should be applied.
Installation/Set-up
Install and use the TV set in accordance with the instructions
below in order to avoid any risk of fire, electric shock or damage
and/or injuries.
Installation
• The TV set should be installed near an easily accessible AC
power outlet (mains socket).
• Place the TV on a stable, level surface to prevent it from falling
over and causing personal injury or property damage.
• Install the TV where it cannot be pulled, pushed, or knocked
over.
• Install the TV so that the TV bottom does not protrude out from
the TV stand (not supplied). If the TV bottom protrudes out from
the TV stand, it may cause TV set to topple over, fall down, and
cause personal injury or damage to the TV.
• For safety reasons, be sure to attach the centre cover to the rear
of the TV when TV in Table-Top condition.
• Only qualified service personnel should carry out wall-mount
installations.
• For safety reasons, it is strongly recommended that you use
Sony accessories, including:

Wall-Mount Bracket SU-WL450
• Be sure to use the screws supplied with the Wall-Mount Bracket
when attaching the Wall-Mount Bracket to the TV set. The
supplied screws are designed as indicated by illustration when
measured from the attaching surface of the Wall-Mount Bracket.
The diameter and length of the screws differ depending on the
Wall-Mount Bracket model.
Use of screws other than those supplied may result in internal
damage to the TV set or cause it to fall, etc.
Transporting
• Before transporting the TV set, disconnect all cables.
• Two or three people are needed to transport a large TV set.
• When transporting the TV set by hand, hold it as shown below.
Do not put stress on the panel and the frame around the screen.
• When handling or mounting the
TV set, do not lay down the TV.
• When transporting the TV set, do not subject it to jolts or
excessive vibration.
• When transporting the TV set for repairs or when moving, pack
it using the original carton and packing material.
Topple prevention
1
Remove the centre cover.
2
Secure the TV to the TV stand.
Sufficient expertise is required when installing the TV to the
Table-Top Stand.
Refer to the Setup Guide supplied with the TV for stand
installation.
Sony is not liable for any damage or injury caused by
mishandling or improper installation.
Screw (M6)
Wall-Mount Bracket
10 mm - 14 mm
TV’s rear cover
10 mm - 14 mm
M6 screw
(not supplied)
Screw (not supplied)
Cord (not
supplied)