GB
6
Preparations for Using the Networking Function
Preparations for
Using the
Networking
Function
You can connect this device to the network
with a LAN cable (10BASE-T/100BASE-
TX).
This section describes the tasks required for
using the networking function of this
device.
Installing this device
Before installation
• Before installation, make sure that the
power to all the equipment is off. To turn
the display completely off, press the
1
switch so that the display changes to
standby mode, then disconnect the power
cord from the wall outlet.
• When you install this device, make sure
that the flat panel display is locked and
stable.
Follow the steps below to install this device
to the FWD series Flat Panel Display.
1
Remove the installed option adaptor
or the panel cover. (Refer to either of
the following illustrations that applies
to your Display unit.)
INPUT
2
RGB / COMPONENT
AUDIO
L
R
AUDIO
OUT
VIDEO
S VIDEO
IN
OUT
IN
OUT
RL
AUDIO IN
VIDEO INPUT
ADAPT
OR
1
2
1
When the option slot is located on
the left side of a Display unit*
* The location of the option slot differs
depending on the model of the Display
unit. If your Display unit has more than
one option slot, install the device in a
COM port, a slot used for the network.
Refer to the Operating Instructions for the
FWD series as well.
Содержание BKM-FW32
