Sony AIT-SDX550, Руководство по техническим характеристикам продукции, Страница: 141 / 206

REQUEST SENSE 6.Command Specification
SONY AIT-2 Turbo drive SDX-550V series Ver.1.0 6-87
MEDIUM ERROR . Indicates that the current command or a previously
acknowledged write-type operation terminated with a non-recovered error condition
that was probably caused by a flaw in the medium, an error in the recorded data or
the cleanliness of the head. This sense key may also be returned if the drive is
unable to distinguish between a flaw in the medium and a specific hardware failure
(sense key 4h). This condition is also marked by the Valid bit being set, indicating
that the information bytes contain residue information.
00 02 END-OF-PARTITION/MEDIUM DETECTED
0C 00 WRITE ERROR–The Read-After-Write Retry limit was exceeded during Write.
Probably caused by a flaw in the media.
11 00 UNRECOVERED READ ERROR-C1, C2 & C3 Error Correction could not correct a
Read Error. Probably caused by a flaw in the media.
11 08 INCOMPLETE BLOCK READ-The drive could not read the AITFormat Group
containing the requested block. Could be caused by head clogging or media
damage.
14 03 END-OF-DATA NOT FOUND–While Reading a AIT format tape, the drive
encountered blank (unformatted) media during a Read operation. This error could
be caused by serious head clogging.
15 02 POSITIONING ERROR DETECTED BY READ OF MEDIUM-Cannot find
destination Group during Space operation.
27 04 PERSISTENT WRITE PROTECT–Append Position Error for WORM
30 00 INCOMPATIBLE MEDIUM INSTALLED-Format violation.
Possible that the Sub-Area cannot be read.
30 02 CANNOT READ MEDIUM, INCOMPATIBLE FORMAT-Format violation, non-AIT-1
Format.
31 00 MEDIUM FORMAT CORRUPTED-AIT format Group GIT, BAT, or Sub-Codes do
not match or are improper.
33 00 TAPE LENGTH ERROR-Attempting to select partition 1 on a single tape.
Requested partition size in MODE SELECT-
Medium Partitions Parameter page is too large (exceeds tape length) or too small
(0<requested partition size in frames<2541).
3B 08 REPOSITION ERROR-Position lost during Read, Verify, Write, Space, Locate,
Seek or Select Partition operation.
50 00 WRITE APPEND ERROR-Cannot find the last frame of the Group and therefore,
cannot append.
52 00 CARTRIDGE FAULT
70 NN DECOMPRESSION EXCEPTION SHORT ALGORITHM ID OF NN-ALGORITHM
ID<=255
03h
83 03 MIC Checksum Error