Buff-n-Dry Machine
– Owner’s
Manual
© SONNY’S The CarWash Factory
SonnysDirect.com
This document is
confidential and proprietary to SONNY’S and cannot be used, disclosed or
Page 29 of 31
duplicated without prior written consent. Content, prices, and availability subject to change without notice.
9.23.2021
10013911-R3.docx3
PREVENTIVE MAINTENANCE
DAILY
1. Check brush for proper operation, listening for any unusual noises from the
equipment.
2. Inspect brush cloth for cuts, grease, or oil. Remove and repair, or replace, any
cloth panel if any of these conditions are found.
3. Check retract and extend for proper operation, smoothness, and correct application
pressure.
WEEKLY
1. Spray lubricant on the clevis pins on both ends of the retract cylinders.
2. Grease the brush shaft bearings. Do not allow grease to come in contact with brush cloth.
3. Drain water from
the compressed air system’s FRL and check lubricant level in the FRL.
FOR THE FIRST MONTH OF OPERATION CHECK ALL HARDWARE AND FITTINGS FOR
TIGHTNESS EACH WEEK. PERFORM THIS INSPECTION TO THE SCHEDULE SHOWN
BELOW AFTER THE FIRST MONTH OF OPERATION.
MONTHLY
1. Inspecting all hardware and fittings for tightness.
2. Grease the UHMW pivot bearings. Do not allow grease to come in contact with brush
cloth.
3. Inspect the bumper stops for wear to ensure the air cylinders have not reached the end of
their travel. If bumper stops are worn, they can be flipped to extend life.
4. Thoroughly clean the equipment and framework.
5.
Sonny’s recommends cleaning your brush flags with glass cleaner in the washer at least
once a month.
NOTE:
Wick-A-Way HUSH brush flags are attached to holders on the
hub using Velcro, so they can be easily removed for cleaning.
Take brush flags out
of the washer, lay flat to dry or reinstall and air dry.
WARNING: DO NOT use detergent on brush flags or place them in the dryer.
SEMI-ANNUALLY
1. Carefully inspect brush equipment cloth for wear and damage. Replace, as necessary.
2. If fluid in reservoirs is contaminated drain, purge, and refill.