Configuration Menu:
(Continued...)
Network Config
Version
: Displays the versions numbers of the software and hardware on your Morpheus
Upgrade Firmware
: Use this option to download new firmware for the Morpheus from the Internet. If
there is new firmware available, then the unit will prompt you if you whether to download it or not.
Note, at this stage, you can press the radio’s
BACK
button to cancel the Morpheus beginning a
firmware upgrade. A Firmware upgrade may take several minutes, so do not switch off the power to
the radio until the operation is complete otherwise the unit may become permanently damaged.
Language
: Allows you to change the display language.
Factory Reset
: Resets the Morpheus back to the default settings as they were when they left the
factory. If you perform a factory reset you will lose all your presets and your wireless network
connection.
Register:
This will display a key that can be used to register the Morpheus on the Reciva Customer
portal:
https://www.reciva.com/
Clock:
Use this option to set the time, to set an alarm and to view the current alarm setting, see
Setting the cloc
k,
Setting the alarm
.
Sleep Timer:
Selecting this option will enable the Morpheus to switch itself off after a set period.
1. After selecting the
Sleep Timer
menu item, the radio will display:
Sleep Timeout
and the sleep
timer value in the form ‘00:00:00’ (hours:minutes:seconds).
2. Rotate the
Dial to change to sleep timer value and then press OK
to begin the sleep timer.
3. The unit will continue to play and will only go into standby mode after the sleep timer has expired.
4. To turn the radio back on again, simply press the
ON / OFF
button.
Backlight:
This option will alter the Morpheus’
backlight
settings.
1. After selecting the ‘Backlight’ menu item, the radio will display its list of three menu modes:
Inactive
,
Active
and
Standby
. These three states are explained below:
· The radio gets into its
inactive
state when there is no user activity for 30 seconds.
· The active state is when there is user activity.
· Standby is the state when the unit is in standby mode.
2. Rotate the
Dial
to highlight the desired
backlight mode and press OK.
3. The display will now show the current backlight value for the selected mode.
4. You can alter this value 0-31 by rotating the dial to increase or decrease it.
5. Press OK to store the new value.
