Sonifex SignalLED Series, Руководство пользователя

Страница: 19 / 28

9
Programming 3
1. Go into Programming Mode by pressing and holding the PROGRAM
(7) button.
2. Press the INPUT (8) button to select the required input.
3. Press the DIVIDE (6) button to enter divide programming. Press the +
(2) button three times to ensure that Section 1 is visible.
4. Press the DIVIDE (6) button again and press the – (1) button to ensure
that section 2 is visible
5. Press the DIVIDE (6) button again and press the – (1) button to ensure
that the dead zone is visible.
If the display is still off then:
1. Press the COLOUR (5) button again and press the + (2) button to
ensure that Section 1 is assigned a colour.
2. Press the COLOUR (5) button again and press the + (2) button enough
times to ensure that Section 2 is assigned a different colour to that
assigned to Section 1.
This should confirm that a colour can be programmed.
Resetting The Sign to Factory Defaults
The sign can be set back to the factory default colours and illumination
mode as follows: Enter the Programming Mode and press and hold the
MODE (3) button for 10 seconds. The sign will now show the original
colour(s) and mode(s).