Connecting the SMA on a New DMZ
The following procedures explain how to configure your gateway appliance on a new DMZ:
l
Connecting the SMA to the Gateway
l
Allowing a WAN to SMA Connection
l
Allowing an SMA to LAN Connection
Connecting the SMA to the Gateway
To connect the SMA 210/410 using Scenario A:
1. Connect one end of an Ethernet cable to an unused port on your SonicWall gateway appliance.
2. Connect the other end of the Ethernet cable to the X0 port on the front of your SonicWall Secure
Mobile Access 210/410. The X0 Port LED lights up indicating an active connection.
3. Configure the SMA X0 IP address. Refer to
Configuring the X0 IP Address
.
Allowing a WAN to SMA Connection
NOTE:
Before continuing, you must add a new SMA custom zone. Refer to
Adding a New SMA Custom
Zone
for more information.
To allow a WAN to SMA connection:
1. Using SonicOS, click the
Wizards
icon in the top right corner of the gateway appliance management
interface.
2. On the
Configuration Guide
page, select the
Public Server Guide
, and then click
Next
.
SMA 10.2 Deployment Guide for the SMA 100 Series
Connecting the SMA on a New DMZ
2
5
