User Manual for the Type 8300 Compatt 6
(and Variants)
UM-8300-Compatt 6
Issue B3
5. Undo and remove the nuts, washers and bolts securing the clamp rings and bump stop
from
the sensor endcap.
6. Push the rubber bump stop free from the clamp rings and housing (use the tapered end of the
Opening Tools to assist if necessary).
7. With the Rubber Bump Stop free, remove the clamp rings.
8. Remove any dirt, silt or water that may have accumulated around the sensor endcap.
9. Using the Opening Tools
to assist to lever the sensor endcap
from the housing until the O-
rings are exposed.
Figure 8–15 Figure 0-13 Remove the Sensor Endcap
10. Using the lint free cloth, clean around the O-ring seals.
11. Remove the Sensor Endcap; slowly pull the sensor endcap
from the transponder housing;
see
Section 8 – Maintenance
48