Sonance Sonamp 875D SE, Инструкция по эксплуатации

Страница: 12 / 28

12
SONAMP ® 875D SE 8-CHANNEL AMPLIFIER
Auto-On
You can set your 875D SE so that any zone will automatically turn ON when it receives an
audio signal, or when it receives a control voltage from an external source (such as a
Sonance Navigator Harbor multi-zone controller). Each zone has two Trigger Mode switches
located on the rear panel: Auto — zone is turned ON when an audio signal is present, and
Volt — zone is turned ON by an external control voltage (see
Figure 14).
NOTE: Setting both switches ON puts that zone in the Ser ial control mode,
disabling the Auto On feature. (See Serial Control , on page 14.)
A
UTO
(Audio) Trigger Mode
When a zone’s A
UTO
switch is set to the ON position, any audio signal arriving at the zone’s active
input connectors (as determined by the I
NPUT
A
SSIGNMENT
DIP S
WITCHES
, see page 8) will activate
the zone for operation. The sensitivity of the zone’s A
UTO
-O
N
circuit can be increased or decreased
by adjusting the A
UTO
O
N
level control on the front panel (see Figure 15).
• Turning the control clockwise increases the sensitivity (less voltage is required to trigger the
A
UTO
-O
N
function).
• Turning the control counter-clockwise decreases the sensitivity (more voltage is required to
trigger the A
UTO
-O
N
function).
The A
UTO
-O
N
trigger sensitivity ranges from 5mV/ch in the full clockwise position to OFF (A
UTO
-
O
N
will not trigger) in the full counter-clockwise position.
In the A
UTO
-O
N
mode the zone will remain ON for approximately 3 minutes after the audio signal has ceased. This
provides ample time to prevent erratic operation from pauses between musical passages or while changing sources.
V
OLTAGE
Trigger Mode
When a zone’s V
OLT
switch is set to the ON position it can be automatically turned ON
by an external trigger voltage that appears at the zone’s E
XTERNAL
T
RIGGER
I
NPUT
connections (see Figure 16).
• The trigger voltage must be between 5V and 24V, either AC or DC.
The 875D SE has individual E
XTERNAL
T
RIGGER
I
NPUT
connections for each zone, and an
additional E
XTERNAL
T
RIGGER
I
NPUT
connection (labeled A
LL
) that will turn all 4 zones ON
from a single voltage trigger.
The E
XTERNAL
T
RIGGER
connectors feature flip-up levers similar to the ones used on the speaker connectors:
1. Open the levers for the zone’s E
XTERNAL
T
RIGGER
inputs.
2. Insert the control wires into the appropriate openings in the connector.
3. Close the levers.
EXTERNAL TRIGGER
INPUTS 5 – 24V AC–DC
ALL CH 1/2 3/4 5/6 7/8
CH
CH
+ – + – + – + – + –
Figure 16:
External Trigger Input
Connections
AUTO
VOLT
AUTO
VOLT
AUTO
VOLT
AUTO
VOLT
TRIGGER MODE
CH 1/2
CH 3/4
CH 5/6
CH 7/8
OFF ON
RS-232
RS-232
RS-232
RS-232
Figure 14:
Auto-On Trigger Switches
AUTO ON
L R L R
3 – 4 5 – 6
Figure 15:
Zone A
UTO
O
N
(Audio)
Trigger Sensitivity
Adjustments