20
SONAMP DSP 2-150 MULTI-CHANNEL POWER AMPLIFIER INSTRUCTION MANUAL
DSP 2-150 AMPLIFIER WITH VP10SUB
OR VP10SUB NC INSTALLATION
1. Read the DSP 2-150 Manual and Network Connection
Instructions.
2. Using assign the VP10SUB or VP10SUB NC subwoofer
preset to the channel or channels being used.
3. In a typical home theater system the signal to the subwoofer
will be from the (LFE) output on your surround receiver or
processor. Connect the (LFE) output to an input on the DSP
2-150 amplifier. When using two subwoofers with the DSP
2-150 amplifier set the output to Mono using the
In/Out settings page, see image below.
Many surround receivers and processor contain an automatic
calibration and equalization system. If yours does contain one,
follow the manufacturer’s instructions on how to complete the
process. The highest performance will be achieved if you complete
this calibration process.
If your surround receiver or processor does not contain an
automatic calibration routine, you will need to do this manually.
Follow the instructions provided with your surround receiver
or processor. A simple SPL (sound pressure level) meter will be
needed to calibrate your system correctly. The use of an SPL meter
is strongly recommended.
4. The DSP 2-150 can also run stereo subwoofers. Connect the
audio source into the left and right inputs on the amplifier. In
Output Setup select Stereo. See image below.
5. Bridging the DSP 2-150 instructions are located on page 7.
