Wi WiRed iNStAllAtiON
combine wireless with wired transmission
1. system must be wireless from source with CtX and to at least one speaker or subwoofer.
2. speaker receiving wireless signal has input set to WiRElEss.
3. From speaker receiving wireless signal, connect balanced cable to liNE out.
4. set input to WiRED on speaker receiving signal by cable, and connect cable to liNE iN.
Continue this set-up for all speakers using wired signal.
note:
- Number of speakers added in a WiRED chain is infinite.
- Volume Zone and volume level set on the speaker receiving wireless signal will effect speakers connected by
cable. set speaker (receiving WiRED signal) volume control to 0 to have same level.
- When set to WiRED input, volume level on wired speaker can be adjusted -20 dB to +20 dB to fine tune volume
levels on that specific speaker.
- the remote for CsW subwoofer will only function when CsW is set to WiRED mode.
rear of csw subwoofer
rear of cls loudspeaker
1. wireless/wired input switch
2. line in, + / ground / -
3. line out, + / ground / -
1
2
3
1
2
3
