ALL WiRED iNStALLAtiON
1. connect a sound source to line in 1 (lED
red) or line in 2 (lED blue).
or two sources to line in 1 and 2.
2. set all speaker to WirED input.
3. connect balanced cable from cgv linE
out (either one, or both) to first speaker/s.
4. set volume on each speaker (-20 db to
+20 db).
(0 is volume unchanged from sound
source connected.)
5. place components
- place Cls speaker in tracks or on wall.
- place CsW subwoofer preferably near
wall/corner.
Plan placement of each component to
make cable connections easy.
6. connect balanced cable to all
components (+, g, -)
Connect all speakers with shielded balanced
cable. The topology should be linear daisy
chain or tree structure. If using tree structure,
avoid branching more than two speakers to a
single line output.
7. connect all components to power
8. setting different volume in different areas
use volume control on speakers to set
individual volume on each speaker.
(0 is volume the speaker is receiving from
connected sound source.)
note:
in wired mode, bass levels on CsW subwoofer can
be adjusted by the remote. if manual volume knob on rear
of CsW is adjusted, this overrides all previous settings
done by remote.
2
4
3
1
3
2
3
4
BASS LEVEL
