7
45. Do not expose the batteries to direct heat radiation and sunshine. It is forbidden to open
them up, to throw them into fire or to short-circuit them.
46. Non-rechargeable batteries must not be charged. Risk of explosion!
47. Do not insert an accumulator instead of the battery, because it provides significantly lower
voltage and efficiency.
48. Do not weld or solder directly to the battery.
49. Store unused batteries in their original packaging, away from metal objects.
50. Do not mix batteries which have already been unpacked. The appliance should be located
so as to allow easy access and removal of the power plug.
51. Due to continuous improvements, the technical data and design may change without any
prior notice.
52. The actual instruction manual can be downloaded from www.somogyi.hu website.
53. We don’t take the responsibility for printing errors which may occur, and apologize for
them.
CAUTION: RISK OF ELECTRIC SHOCK!
Do not attempt to disassemble or modify the unit or its accessories. In case any part is
damaged, immediately power off the unit and seek the assistance of a specialist.
In the event that the power cable should become damaged, it should only be replaced by
the manufacturer, its service facility or similarly qualified personnel.
Do not cover!
Covering the unit can cause overheating, fire or electric shock.
THE REMOTE CONTROLL IS NOT A TOY. KEEP OUT OF REACH OF CHILDREN.
PUTTING INTO USE
1. Before installation, carefully remove packaging, and make sure not to damage the unit or
the power cord. If you find any damage, the unit must not be operated!
2. The appliance is exclusively for use in a dry, indoor environment.
3. It is forbidden to mount the unit directly below a power socket!
4. Mount the unit on the wall as shown in Figure 3:
a. Keep the large wall mount bracket to the wall at a distance of at least 390mm from the
ground, then mark the locations of the holes.
b. Make holes in the wall for the dowels. Before mounting on the wall, always make sure
that the wall has sufficient load bearing capacity, and use fasteners suitable for the wall
material.
c. Insert the dowels into the holes, keep the bracket to the wall and secure it.
d. Hang the product onto the mounting bracket.
e. Keep the small bracket to the bottom of the product, mark the locations for the holes, and
then attach it to the wall, as well as to the product.
5. Put the supplied pebbles and logs in the appliance.
6. Make sure that the main switch of the appliance is in the off (0) position.
7. Plug the unit into a standard grounded wall socket. Now the unit is ready for operation!
