21
EN -Functions / H - Funkciók / SK - Funkcie / RO - Funcţii / SRB-MNE - Funkcije / CZ - Funkce /
HR-BIH - Funkcije
ELECTRIC FIREPLACE
FEATURES
● electric fireplace, with built-in fan heater, to heat up the air of indoor premises ● cozy flame-effect ● built-in LED light source ● 1000
W / 2000 W heating output ● thermostat ● overheating protection
OPERATION
The handle on the front of the device is a design element only, it cannot be opened.
The unit can be operated using the rocker switches located on its backside, or with the thermostat.
The unit may emit a slight odor, when it is turned on initially, which is not a malfunction. It is harmless and evaporates quickly.
Use the main switch (3) to turn the unit or the light effect on. The light effect can thus used independently without setting a heating
stage. Then you can activate the fan heating stages using switch I (1000 W) and I+II (2000 W).
Switch II itself does not switch anything without switch I.
You can set the constant room temperature using the thermostat (5). In modes I and II, the appliance will switch on when the ambient
air temperature falls below the value set. As the set temperature is reached, the fan and heating elements switch off. If you would prefer
a higher temperature, turn the thermostat’s button clockwise, if you want lower temperature, then turn it counterclockwise.
You can switch off every functions using the main switch.
The built-in energy-saving, electronically controlled LED light source does not require replacement, it cannot be replaced.
If overheating occurs, the overheating protection function will switch the unit off, e.g. when the air inlets and outlets are covered. Power
off the unit by unplugging it from the electric outlet. Allow the appliance to cool (for at least 30 minutes). Check whether the air inlets and
outlets are obstructed or not, and clean them if necessary. Switch on the unit again. If overheating protection activates again, power off
the unit by unplugging it from the electric outlet and contact the service facility.
SPECIFICATIONS
power supply:
.......................
230 V~ / 50 Hz
heating output [
]:
............
1000 W / 2000 W
light source [ ]:
....................
LED, 5 W, not replaceable
maximum output:
..................
2005 W
IP protection:
........................
IP20: Not protected against ingress of water.
dimensions of heater:
...........
D41 x 65 cm
weight:
..................................
14 kg
length of power cable:
..........
1,6 m
noise level:
............................
50 dB(A)
