23. Do not locate the appliance directly under or next to a wall outlet.
24. If any irregular operation is detected (e.g., unusual noise or burnt odor from unit), immediately switch it off
and remove the power plug.
25. Make sure that no foreign objects or liquid can enter the unit through the openings.
26. Protect from dust, humidity, sunlight and direct heat radiation.
27. Power off the unit by unplugging it from the electric outlet prior to cleaning.
28. Do not touch the unit or the power cable with wet hands.
29. The appliance may only be connected to properly ground 230 V AC/50 Hz electric wall outlets.
30. Unwind the power cable completely.
31. Do not use extension cords or power distributors to connect the unit.
32. Do not lead the power cable on top of the appliance or near the heat radiating surface.
33. Do not lead the power cable under carpets, door mats, etc.
34. The appliance should be located so as to allow easy access and removal of the power plug.
35. Lead the power cable so as to prevent it from being pulled out accidentally or tripped over.
36. The unit is intended for household use. No industrial use is permitted.
37. Due to continuous improvements, the technical data and design may change without any prior notice.
38. The actual instruction manual can be downloaded from www.somogyi.hu website.
39. We do not take the responsibility for printing errors which may occur, and apologize for them.
Do not cover! Covering the unit can cause overheating, fire or electric shock!
Caution: Risk of electric shock!
Do not attempt to disassemble or modify the unit or its accessories. In case any part is damaged, immediately
power off the unit and seek the assistance of a specialist.
In the event that the power cable should become damaged, it should only be replaced by the manufacturer, its
service facility or similarly qualified personnel.
FEATURES
Combined heater – halogen and carbon-fiber heating element ● 1200 W output per heating element ● IPX4 protection against splashing water ● for
in- and outdoor use ● oscillation can be switched ON/OFF ● can be controlled by remote control or with touch-buttons ● 6-hour switch off timer ● tip-over
protection ● plastic carrying handle
STRUCTURE (Figure 1.)
1. radiant surface with protective grid
2. main switch
3. halogen heating element
4. carbon-fiber heating element
5. ON/OFF switch
6. heating mode selector button
7. oscillation switch
8. switch off timer
9. display
10. remote control
11. carrying handle
12. power cable
INSTALLATION
1. Before switching on for the first time, carefully remove the packaging material taking care not to damage the appliance and power cable. Do not use the
product if it is damaged in any way.
2. Stand the appliance on a firm, horizontal surface. For proper operation, the free flow of hot air has to be ensured, so observe the minimum placement
distances shown in Figure 2.
3. The main switch of the appliance (2) must be set in „0” (OFF) position.
4. Connect the unit’s power cable into a standard grounded wall outlet. This completes the setup of the unit, which is ready for operation.
OPERATION
Switch the main switch (2) of the appliance on.
You can operate the appliance using the supplied remote control or the touch-buttons.
The touch-buttons on the appliance and the buttons on the remote control marked with the same symbols have the same function.
– Switching the appliance ON/OFF. When switching the unit on, it operates with the halogen heating element, without oscillation and the switch off
timer.
