UNPACK1NG AND CHECKOUT
Unpack the carton carefully and check for exterior damages.
Check that the volume control is in the OFF position, the squelch control in the
ANL-OFF position and the standby-operate-call switch in OPERATE position.
press the dent of the battery compartment iid and puii it out toward the bottom.
L ift out the battery holder and insert 8 dry celis into the holder as indicated.
© to © , © to © pole. Leave the 2 dummy batteries in the holder as they are.
If you use rechargeable batteries, insert 10 pièces of them in the same manner
as above but remove the dummy batteries.
Snap the battery holder onto the snap connector provided and reinsert the holder
into the compartment.
Replace the compartment lid by inserting it straight from the bottom up until
it snaps in rightly.
Then switch the transceiver ON by rotating the volume control clockwise and
check that the meter needle moves into the red field. If the meter needle does
not move, switch OFF immediately and check if the standby-operate-call switch
is in the OPERATE position. If this is the case, open the battery compartment
to remove the battery holder to ensure that the batteries are correctly in-serted.
Now turn the volume control until noise is heard from the speaker. Then extend
the rod antenna to the füll length.
5 —
Содержание TS- 5612
