Copyright © Somfy SAS 5/2019
P-0039CBG
www.somfysystems.com
The procedure to delete an RTS sensor is the same.
a)
PRESS & HOLD
the
PROGRAMMING BUTTON
on the back of Control 1 until
the shade jogs.
b)
BRIEFLY PRESS
the
PROGRAMMING BUTTON
on the back of Control 2.
The shade jogs.
CONTROL 1:
Previously programmed
control - single channel or
the channel (1-5) of a multi-
channel remote.
CONTROL 2:
Second control to be added or
deleted - single channel or
the channel (1-5) of a multi-
channel remote.
ADD OR DELETE A CONTROL
The shade must be programmed.
This feature temporarily prevents the motor from
responding to any previously programmed remote
commands.
1)
PRESS & HOLD
the motor
head
PROGRAMMING BUTTON
until the shade jogs.
2)
BRIEFLY PRESS
the motor
head
PROGRAMMING BUTTON
,
the shade jogs twice. Sleep Mode
is activated.
ADJUSTING THE SPEED
LED blinks alternately in green and yellow during the adjustment.
1) Move the shade away from the end limits.
PRESS & HOLD
the
UP, MY/STOP
and DOWN
buttons simultaneously, until the shade jogs. The shade will move up
and down automatically in ten second cycles.
2) To increase the speed,
PRESS & HOLD
the
UP
button
until the shade jogs. Repeat as needed.
Maximum speed is achieved when the shade no
longer jogs when the UP button is pressed.
3) To decrease the speed,
PRESS & HOLD
the
DOWN
button until the shade jogs. Repeat as needed.
Minimum speed is achieved when the shade no
longer jogs when the DOWN button is pressed.
4) To confirm the new speed,
PRESS & HOLD
the
MY/STOP
button until the shade jogs.
10 Sec.
10 Sec.
RESETTING THE MOTOR TO FACTORY MODE
PRESS & HOLD
the
PROGRAMMING BUTTON
on the motor
(shown below) for approximately 12 seconds during which
the shade will jog 3 separate times.
All programmed remotes and limit settings will be erased.
Motor is now reset to
factory mode
. Motor limits will need
to be re-established.
To delete:
First send the shade to the current “my” position, then
PRESS & HOLD
the
MY/STOP
button for 5 seconds. The shade will jog to confirm deletion.
USING THE INTERMEDIATE “MY” POSITION
SETTING INTERMEDIATE "MY" POSITION
2)
PRESS & HOLD
the
MY/STOP
button until the shade jogs. The "my"
favorite position is set.
If the shade is in motion, first stop it by pressing
MY/STOP
and then
MY/STOP
again
to send it to the “my” position.
While the shade is stationary, a simple press of the
MY/STOP
button will move the shade to the “my”
intermediate position from any shade position.
OR
3) To set a NEW "my" position, repeat steps 1 and 2.
1) Move the shade to the desired position
and press
MY/STOP
button to stop the
shade.
ENABLING SLEEP MODE
NOTE:
If step 3 is not performed, Sleep Mode will automatically
disable after approximately 10 minutes.
2x
3X
DISABLING SLEEP MODE
3) Press the motor head
PROGRAMMING BUTTON.
The shade jogs and the remote
commands are enabled.
OR
Programming
Button
