SOMFY INSTRUCTIONS
TELIS RTS MODULIS
REMOTE CONTROLS
Part #’s
1810663 Telis 5 Modulis RTS Silver
1810664 Telis 5 Modulis RTS Lounge
my
Down
Stop
Up
Channel
Selector
LED
Channel
Indicator
Tilt
Scroll
Wheel
BACK
Programming
Button
PROGRAMMING – INITIAL INSTALLATION
1.
Set the RTS motor or receiver in Programming Mode. (Refer to the installation instruction of the relevant RTS motor or receiver for this procedure.)
2.
Select a channel to be memorized
by pressing the Channel Selector
button. The LED lights will illuminate
up each time the Channel Selector
Button is pressed to show what
channel is being operated.
3.
Using a paper clip, pen or similar
device, briefly press the Programming
Button (for 1 second) located on
the back of the remote. The RTS
motor or receiver will confirm the
addition of the remote in their
respective manners.
Note: During initial programming it is recommended to provide power only to the motor or RTS receiver being programmed.
Programming
Button
BACK
PROGRAMMING - ADDING A NEW REMOTE
1.
With your current remote, select the shade
to operate by pressing the Channel Selector
Button. The LED lights will illuminate
each time the Channel Selector Button is
pressed to show what channel is being
operated.
2.
Using a paper clip, pen or similar device,
press and hold the Programming Button
on the back of the remote until your
window shade jogs up then down.
3.
Get the new remote and select the
new channel.
4.
Using a paper clip, pen or similar device,
press and hold the Programming Button
on the back. The window shade will jog.
This remote will now operate your shade
or awning.
my
my
C - 0002
my
Channel
Selector
LED Lights
© Copyright SOMFY SYSTEMS, INC. 7/2009
PAGE1 REV 1
BACK
BACK
1.
Select the shade to operate by pressing the
Channel Selector Button. The LED lights will
illuminate each time the Channel Selector
Button is pressed to show what channel is
being operated.
PROGRAMMING - SETTING FAVORITE POSITION
my
2.
Using the up ( ) or down ( ) buttons
or the scroll wheel, bring the window to
your favorite position, for example halfway
down or slats open. Press the center ( )
button to stop movement at the desired
location.
my
DOWN
UP
TILT
SCROLL
WHEEL
Pen
Pen
Programming
Button
Programming
Button
my
Pen
Pen
