SOMFY STRUXURE OUTDOOR, Быстрый старт

Страница: 3 / 6

Version 2.1
Programming

NOTE: It is always easier to program motors before they are attached to the frame.

NOTE: Pick one remote to program and use as a master. Program everything to this
one first.

NOTE: To simplify, only connect power to the board you are programming.
1. Press & hold “ PROG ” button on the board until both S1 and S2 LED flashes and the
motor jogs back and forth.
2.Briefly press “ PROG ” button on the board to choose the desired output, S1 or S2, until
the LED flashes.
•
NOTE: So long as the yellow LEDs are flashing, you are still in Programming mode.
3. On the RTS control, select the desired channel by pressing the button at the bottom.
The four LEDs on the bottom of the remote will indicate which channel is selected.

(1,2,3,4, all lights will flash for Zone 5, and this zone is used for the “ All Zone ” function.
Wireless sensors are also to be programmed to this zone.)
4. On the RTS control, press “ Up ” and “ Down ” simultaneously until the motor jogs.
•
To check for correct motor direction, press the “ Up ” button.

If the pergola louvers open, the rotation direction is correct.

If the pergola louvers close, press & hold the “ My ” button until the motor jogs. The
rotation direction is corrected. Press the “ Up ” button to check once more.
5. On the RTS control, briefly press “ Up ” and “ Down ” simultaneously.

IMPORTANT: DO NOT INTERUPT THE MOVEMENT. The motor will find the
end
- limits automatically during a “ Self learning phase ”.
6. Press the “ Up ” or “ Down ” button to reach the desired position for ice and snow.
When the motor is in position, press & hold the “ My ” position until the motor jogs to
confirm the settings.
•
NOTE: This position must be set regardless of location of pergola installation.
7. Briefly press the Programming Button on the back of the RTS control. The motor
jogs, and programming for the desired motor is complete.
8. Programming for the specified motor is complete. To program another motor on the
same board, repeat the process from step one. To Program a second remote with the
same system, or to program an
“ All ” zone, refer to the next page.