35
Copyright © 2005 - 2014 Somfy SAS. All rights reserved.
EN
Non contractual images
2)
The wheel must be prevented from moving back and forth inside the winding tube:
+ Either by securing the winding tube to the wheel
using 4 Ø 5 mm Parker screws or 4 Ø 4.8 mm steel
pop rivets located between 5 mm and 15 mm from
the outside edge of the wheel, irrespective of the
type of winding tube.
The screws or pop rivets must only be fastened on
the wheel and not on the drive.
+ Or by using a wheel lock, for non-smooth tubes.
3)
Fit the tube end into the winding tube.
2. 1. 4. Mounting the tube-drive assembly
2. 1. 4. 1. Star head drive
1)
Fit the tube-drive assembly to the end support (
F
).
2)
Fit the tube-drive assembly to the drive support (
G
).
Depending on the type of support, position the
retaining ring (
H
QUBGX {
ring, a lockable retaining ring (
I
) must be used).
2. 1. 4. 2. Round head drive
1)
Fit the support to the drive head, and then the
removable side plate.
2)
Slide the tube-drive-removable side plate assembly
into the head rail.
2. 2. WIRING
Cables routed through a metal internal wall must be
protected and insulated by sleeving or sheathing.
Secure the cables to prevent any contact with moving
parts.
_ { { {Z[G\Q {
]\
£{ _ {
cable.
1
Leave the drive power supply cable accessible: it must be easily replaceable.
Always make a loop in the power supply cable to
1
prevent water from entering the drive!
-
Switch the power supply off.
-
Connect the drive according to the information provided
in the table below:
Cable
Neutral
(N)
Live
(L1)
Live
(L2)
Earth ( )
230 V
50 Hz
Blue
Brown
Black
Green-yellow
15 mm
5 mm
L1
2)
3)
1
F
G
1)
2)
H
I
1)
2)
L ≤ 50 m
230 V
50 Hz
N L1 L2
OFF
Содержание HOME MOTION Orea WT Series
Страница 2: ......
