Copyright © 2009-2011 Somfy SAS. All rights reserved.
Easy Sun io
9
EN
6.1 Recommendations
The Easy Sun io wall bracket must be installed centrally between the products to be controlled.
Choose an accessible location which allows easy consultation and use.
The building in which the product is used might reduce the radio range. The radio range is 20 m
through 2 concrete walls.
dE3>U#2E3#9?65J#9?7R3#H3@J93#?@8G57R#2E3#N?01#<M7#5J#O?II#H9?>U32;
The use of a radio appliance (e.g. Hi-Fi radio headphones) operating on the same frequency
may cause interference and be detrimental to the product’s performance.
Only install indoors.
Never install the product on or near any metal surfaces as this may reduce the radio range.
6.2 Fixing the wall bracket
V@8G#2E3#N?01#<M7#5J#H9?>U32#2J#2E3#O?II#?2#?#E35RE2#2E?2#?IIJO0#2E3#650=I?1#2J#H3#93?6#3?05I1;#
-Drill two holes (5/6 mm in diameter) one above the other
and approximately 37 mm apart.
-Mount the wall bracket using the screws supplied.
-Insert the cover mounting brackets in their notches, with
the magnetic pad at the bottom, and press until you hear
?#>I5>U#2J#?@8G#2E3#>JA39#J7#2E3#H9?>U32;
-Place the Easy Sun io on its mounting bracket.
37 mm
Ø 5/6 mm
7. TIPS AND RECOMMENDATIONS
7.1 Questions about the Easy Sun io?
Observations
Possible causes
Solutions
One of the applications of
the selected group is not
activated when a button (
/
/
)
is pressed on
the Easy Sun io.
The motor or receiver is not part of
the group.
Add the motor or receiver to the
group, see the section
«
Group
editing
»
.
The motor or receiver is in local mode. See alert « ».
The motor is in heat protection mode. See alert « ».
The motor or receiver is paired to
a wind sensor and the wind speed
exceeds the set sensitivity threshold:
the
«
»
symbols are displayed
on the Easy Sun io screen.
Wait for the wind to drop
(the
«
»
symbols
disappear) and press the Easy
Sun io button again.
None of the applications
of the selected group is
activated when a button (
/
/
)
is pressed on
the Easy Sun io.
No motors or receivers are in the
group.
Add motors or receivers to the
group, see the section
«
Group
editing
»
.
External radio equipment is interfering
with the radio reception (e.g. Hi-Fi
radio headphones).
Turn off all radio equipment
nearby.
See alert « ».
The Easy Sun io is in automatic
mode.
Remove the Easy Sun io from
its bracket to switch to manual
mode.
An application stops while
moving.
The application has encountered an
obstacle.
See alert « ».
Another control point is sending an
order to the motor or receiver.
See alert « ».
6. INSTALLATION
Содержание Easy Sun io
Страница 58: ...12...
