Digital Electricity™ is a Limited Power Source which allows to utilize standard 18AWG 2-Conductor Cable without
conduit while confirming to the National Electric Code standards for building installations. When the Transmitter and
Digital Electricity™ Power Panel for SDN with Receiver are pair together the Digital Electricity™ system is formed.
A fully loaded Transmitter provides 8 channels of Digital Electricity™ up to 600W per channel, total 3000W per unit.
Each of the 8 connected Receivers will provide up to 3A at a nominal output voltage of 336V DC per unit.
The Digital Electricity™ Transmitter and Receiver are listed products certified to safety and EMC standards by
Nationally Recognized Test Laboratories (NRTLs). If a person or foreign conductor comes in contact with the wiring,
power is disconnected, preventing fire, equipment damage and personal injury.
I. OVERVIEW
C O N N E C T I O N S
L E D s
3 of 15
DE Outputs
LED
NORMAL STATES
LED PATTERN
NOTE
Normal Operation
Normal operation
Boot-Up
Start-up sequence occurs when power is first applied to the receiver
Pre-Charge DE
Part of normal set-up sequence
Pre-Charge Load
Part of normal set-up sequence
FAULTS
LED PATTERN
FAULT CODE
TROUBLESHOOTING
Load Connection
2 Blinks
Connection problem between Receiver Output and load
Check Receiver Output polarity; Check connections to load
Overload
3 Blinks
Load Current too high
Reduce load; Check wiring
Transmitter
4 Blinks
Transmitter power issue
Check Transmitter card(s); Check wiring from Transmitter
Temperature
5 Blinks
Receiver over temperature
Reduce ambient temp. surrounding Receiver; Reduce load
Short Circuit
6 Blinks
Short circuit detected between Receiver and load
Check wiring; Check load for short circuit or ground fault
Internal Failure
8 Blinks
Internal hardware failure
Contact Voltserver
*included with Digital Electricity™ Power Panel for SDN #1870628
LEDs
Management Port
Power Input
Power Output
Digital Electricity™
Transmitter
Digital Electricity™
Receiver
