Assigning Specific Channels to Shade (Multi-channel transmitters only)
1) Using a paperclip or pen, press and hold the
PROGRAM button
on the
previously addressed transmitter until the shade jogs.
2) Select the desired channel (1-4 or all) by momentarily pressing the
Channel
Selector Button
on the multi-channel transmitter.
3) Press and hold the
PROGRAM button
on the multi-channel transmitter until
the shade jogs. Additional (new) channel is now added to shade memory and
can be used to operate shade.
Note: To prevent unwanted Channel/Transmitter assignments, ALL PREVIOUSLY
PROGRAMMED SHADES should be UNPLUGGED until Programming is complete.
Deleting Specific Channels/Transmitters
1) Using a paperclip or pen, press and hold the
PROGRAM button
on the
previously addressed transmitter until the shade jogs.
2) Select the desired channel (1-4 or all) or transmitter (single channel) to be deleted.
3) Press and hold the
PROGRAM button
on the transmitter until the shade
jogs. Channel or transmitter is now deleted from shade memory and will
not operate shade.
CT-32RT-12V
CordLift WireFree Programming & Operation Instructions
Previous
transmitter
Program
Button
1) Insert reset tool into connector on motor.
2)
To delete all the transmitters
, press and hold the
program button
located
on the reset tool for 7 seconds. Release the
programming button
after
the LED starts flashing. The motor jogs one time. The transmitters are
deleted but the limits remain in memory.
3)
To delete all previous settings,
press and hold the
PROGRAM button
located on
the RESET TOOL (approximately 12 seconds) until LED blinks rapidly and extinguishes.
(Motor is now reset to factory mode.) Motor limits will need to be reset.
STEP SEVEN
Resetting Motor (Erasing all Previously Programmed Limit Settings and Channels)
TM
my
Channel
Selector
Previous
transmitter
Program
Button
my
Channel
Selector
New
transmitter
Program
Button
