152134 Rev 03/15
Reprogram From Factory Setting
• STEP 1:
Using a paperclip, press and hold the
PROGRAM BUTTON, located on the back side of
the motor casing until window covering jogs 3
times, then release button. All transmitters and
limits will be erased (motor is now reset to Factory
Mode.) Motor limits will need to be reestablished.
Please return back to Programming Mode to initiate
programming process.
• STEP 2:
Select the desired channel on the remote.
• STEP 3:
Press and hold the
“Up”
and
“Down”
buttons simultaneously until the
shading jogs.
• STEP 4:
Press and hold the
“Down”
button to move the shading to the desired
lower limit. (Shading will move in 3” increments).
• STEP 5:
When the shading nears your desired lower limit, press and hold the
“My”
(stop) and
“Up”
buttons simultaneously until the shading begins to move up,
then release.
• STEP 6:
Press the
“My”
(stop) button when the shading reaches the desired
upper limit.
• STEP 7:
Push the
“Up”
or
“Down”
button to adjust your shadings to the precisely
desired upper limit.
• STEP 8:
When the shading has reached the desired location, press and hold the
“My”
(stop) and
“Down”
buttons simultaneously until the shading begins to move
down, them release.
• STEP 9:
Once the shading stops at the lower limit, press the
“My”
(stop) button
for 2 seconds until the shading jogs. This confirms both limits.
• STEP 10:
Using a paper clip, press and hold the
“Program”
button on the back
of the transmitter until the shade jogs. The transmitter is now programmed.
h
