Somat DH-100, Руководство по эксплуатации

Страница: 18 / 23

18
OPERATING INSTRUCTIONS
After the unit has been connected to the proper power source, the proper rotation of the
paddles have been verified and the drain line has been routed its desired drain location,
you are ready to process.
1. Please use the touch screen for all operation commands described below.
2. Open the top lid, clean the screen filter and make sure the front discharge door is
closed. Load the product to be processed into the dehydrator. The maximum fill level
would be to the top of the paddles attached to the auger.
3. Close the top lid.
4. On the touch screen you will have access to the Home screen. Simply press the Start
Batch button, confirm that you have cleaned the filter and the unit will run until the
cycle is complete. The system status will be displayed on the bottom the screen.
5. Other miscellaneous monitoring information is displayed on this and the more
information screen and is not necessary for daily operation. Information on these
screens maybe helpful for trouble shooting in the event of a failure.
6. When the unit has completed the batch it will automatically enter a 60 minute cooling
mode. The timer on the touch screen will begin to count down the time left for the
cooling cycle.
7. When the cooling cycle is complete a suitable container should be placed under the
discharge door on the front of the unit and the discharge door opened. Press the Start
Discharge button to begin the discharge process. This process will shut off
automatically. After discharge is complete, turn the power
OFF and clean door area.
Close the discharge door.
8. You are now ready to start a new batch. If any troubles occur during the processing of
a batch, the unit will shut down and an alarm banner will be displayed on the touch
screen indicating the issue and the probable cause.
Please call the Somat Service
Department at 800-237-6628 x 176 for assistance.