User Manual
CARE AND CLEANING
• To avoid electrical shock which can cause severe personal injury or death, unplug power
cord or open circuit breaker to oven before cleaning or removing light bulb.
TROUBLESHOOTING
COMPLAINT
POSSIBLE CAUSE
REMEDY
Dim oven light
Cooking at low power level
This is normal
Steam forms on oven door
When cooking foods in a microwave steam is
generated.
This is normal
Hot air expelled from vents
Foods cooking in a microwave may release
heat
This is normal
Oven does not start
Power cord not plugged in correctly
Fuse blown or circuit breaker open
Malfunctioning outlet
Door not closed
Plug cord into outlet correctly
Replace fuse (should be repaired by
authorized servicer) or reset breaker
Test outlet with other electrical appliance
Close door
WARRANTY
1 YEAR REPLACEMENT WARRANTY
• This warranty is effective from the time of purchase.
• This warranty is not effective if damage occurs because of accident, carelessness, improper installation, lack of
proper set – up, supervision when required or if the equipment is installed or operated in any manner contrary to
the installation and operating instructions.
• Work performed by unauthorized personnel or unauthorized service agencies voids this Warranty
• This warranty does not apply to, and Solwave is not responsible for any warranty claims on products sold or used
outside of the contiguous United States.
• This equipment is intended for commercial use only. Warranty is void if equipment is installed in anything other
than commercial applications.
• Cleaning the interior and exterior will
require a mild detergent, water and a
soft sponge or cloth.
• Do not use cleaners that include
ammonia or citrus.
• Do not use water pressure cleaning
systems on your microwave.
• Inspect air vents monthly and clean
using a damp cloth.
1. Open the oven door and press "3" for 5 seconds to enter Service Mode.
2. "SERVICE" will be displayed.
3. To check the number of times the door has been opened or closed, press the number "3". The LED will display the times.
4. To clear this number, press number "4". "4-CLEAR" will be displayed. Press the green "START/CONFIRM" button and "CLEARED" will be
displayed. The message will be cancelled.
5. Press the red "STOP/RESET" button to enter Door Open Mode.
6. Close the door to enter Ready Mode.
1. In Power Up or Ready Mode, press the green "START/CONFIRM" and "0" buttons simultaneously to Restore Factory Defaults.
Service Mode
Restore Factory Default Settings
