Solution SLE40i, Инструкция по эксплуатации

Страница: 6 / 20

06
Installation Instructions
Installation
1. Centrally and in-line with the top of the
fireplace opening, drill and plug a hole and
fit the eyelet (supplied) in the rear wall of the
chamber. Ensure the fittings you use are
suitable for the structure into which you are
fitting the eyelet. (Fig. 5)
2. Stick the provided foam gasket on the back
of flanges. (Fig. 6)
3. Position the appliance in front of the fireplace
opening and connect the power cables,
ensuring no power cables are pinched or
trapped. The trailing socket can be located
to the left or right of the appliance.
4. Thread the steel cable of the stability system
through the left hand hole (1)in the front of
the appliance, loop it through the eyelet
(2) and bring the loose end back through the
right hand hole (3) in the front of the
appliance. Thread again through hole (4)
and bring the loose end back through the
hole (5). (Fig. 7)
5. Without damaging the surface on which the
appliance is to be fitted move the appliance
into position, gently pulling the steel cable.
Do not pull the cable too tightly. The stability
system is a safety feature to prevent the fire
from falling fowards.
6. Pull the cable and insert the loose end into
hole (6). Cut off the excess cable length
with wire cutters if the wire is too long, leaving
enough to enable possible future removal if
required.
7. As an alternative method of providing
stability, it is possible to screw fix the
appliance to the wall or back panel through
the flanges. Take care when drilling to ensure
that the edges of the opening are not
“blown”.
1
2
3
4
5
6
Fig.5
Foam Gasket
Fig.6
Fig.7
1
2
3
4
5
6