06
07
03
Luminous Distribution
1. Super Capacitor battery powered Sunlike Pro lights are visibly brighter
than other outdoor solar lights, and their performance overall is
more reliable.
2. To charge the battery fully may take up 6 to 12 hours.
3. The rechargeable battery can work continuously for 10 hours at
full power.
4. Output will be reduced to 40% when the battery is below 40% of
its capacity.
5. Battery will stop charging when the ambient temperature is below
-58°F or above 140°F.
Battery Status is indicated by the red indicator on the lighting fixture
as follows:
> Slow red light flashing (Every 2.5s) = Working
> Slow red flashing (Every 5s) = Open circurt
> Red light continuously on = Non-working
> Quick red flashing (Every 0.5s) = Charge fault
> Quick red flashing (Every 0.1s) = Over current or Short circurt
Storage
To avoid over discharge of the battery during storage, please recharge
the lighting fixture every 4 months. Use the dedicated charger to charge,
reset the switch when done.
(IAP) Intelligent Adaptive Program Battery Control Technology
In order to extend the off-grid autonomy of the Sunlike Pro under
shady trees, heavy rain, and thick clouds, our controllers now
integrate an adaptive smart control feature to actively track battery
capacity and adjust light output accordingly. Before integrating this
feature, selecting a light output percentage on the remote would yield
an accurate percentage of max LED brightness. Now with (IAP), the
controller actively monitors the battery and regulates the electrical
current to the LEDs. The controller makes light output of the selected
percentage on the remote relative to battery capacity rather than max
LED output. This smart-control feature can increase our off-grid
performance by up to 40%.
ATTENTION
Battery cannot be replaced on your own. Please conntact SOLTECH
for any battery’s questions.
After opening the Sunlike 30W Pro, package, you will notice that
the solar panel is covered, and the indicator is flashing every 5 seconds.
It signifies that the fixture is in open circuit mode. Once the fixture
is taken out of the package, and the solar panel is no longer covered,
the Sunlike 30W Pro will automatically turn on, and the indicator
will begin flashing every 2.5 seconds. The light head will then turn
on for 1 minute and then shut off again. It means the fixture is
switching from open circuit mode to standard working mode.
If you wish to shut off the light, you must first cover the solar
panel. Then press the off button on the remote. You can also just
press the off button to turn off the lights during the night. When
the solar panel detects light, the fixture will activate and resume
normal operation again.
04
Battery Notes
Sunlike Pro
30W Type III
