GE Lumination LDXB Series, Руководство по установке

Страница: 1 / 11

Installation Guide
IND544 | A-1026317
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING / AVERTISSEMENT
RISK OF ELECTRIC SHOCK
• Turn power off before inspection, installation or removal.
• Properly ground electrical enclosure.
RISK OF FIRE
• Follow all NEC and local codes.
• Use only UL approved wire for input / output connections. Minimum
size 18 AWG or 14 AWG for continuous runs.
Prepare Electrical Wiring
Electrical Requirements
• The LED driver must be uspplied with 120V to
277V for LDXBxx0xxxxxxx fixtures and 347V for
LDXBxxDxxxxxxx fixtures. 50/60 Hz and connected
to an individual properly grounded branch circuit,
protected by a 20 ampere circuit breaker. Use min.
90
o
C supply conductor.
Grounding Instructions
• The grounding and bonding of the overall system
shall be done in accordance to local electric code of
the country where the luminire is installed.
RISQUES DE DÉCHARGES ÉLECTRIQUES
• Coupez l’alimentation avant d’inspecter, installer ou déplacer le luminaire.
• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation électrique.
RISQUES D’INCENDIE
• Respectez tous les codes NEC et codes locaux.
• N’utilisez que des fils approuvés par UL pour les entrées/sorties de connexion. Taille
minimum 18 AWGou 14 AWG pour les rangées continues.
Save These Instructions
Use only in the manner intended by the ma nufacturer.
If you have any questions, contact the manufacturer.
Lumination
®
LED Luminaire
LDXB Series
This device complies with Part 15 of the FCC Rules. Operation is subject
tothe following two conditions: (1) This device may not cause harmful
interference,and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAN ICE-005(A)/NMB-005(A)
Note: This equipment has been tested and found to comply with the
limits for a Class Adigital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.