Media should
come off the top of
the roll, rather than
under. The stand-
ard media path is
to feed over the
top bar and under
the bottom bar as
seen in the picture
at left. The bottom
bar can be lowered
and raised to adjust
tension.
05
set up
Use the supplied
allen wrench to
loosen hub lock
on bar. Slide one
hub off, load roll,
replace hub and
tighten hub lock.
Don’t press the
hubs too tightly
against the
media roll,
it needs to spin
in place.
Install your power
cord into the
back of your
machine, just
under the on/
off switch. 120V
machines are
supplied with a
power cord.
Be sure the washer
is on the outer side
of the blue wall
when you install
your media bar.
Tighten the black
handles snugly.
The bar should not
spin during usage.
For particularly heavy rolls, an
alternative film path is recommended.
Try feeding it between the two rolls
rather than directing it around the
bars. You’ll want to raise the lower bar
close to the top bar to prevent the film
from slipping out of place. As your roll
gets lighter, simply re-route the media
to the standard feed path.
Standard
Feed
Heavier
Rolls
