7.1.1.2 MENU LIST AND VALUE CHANGING GUIDE; DAY, NORMAL CUT-OUT TEMPERATURE:
Press the UP button to enter the menu list.
Toggle through the menu items by pressing the UP & DOWN buttons until “dno” is displayed.
When “dno” is displayed, press the ENTER button to show the current set temperature.
While any parameter name is displayed, if the BACK button is pressed the JEA will return to
the Home display (showing regulation temperature).
Toggle through the available values by pressing the UP & DOWN buttons.
NOTE: If a value is changed the controller will immediately save this as the new
operational value.
Press the BACK button to return to the parameter list. Press the back button again to return to the home
display (showing the regulation temperature).
7.1.1.3 LEARNING ALGORITHM RESET
Learning Algorithm reset operation is needed to reset the learning algorithm timers. It does NOT
change any of the registered parameter values. Menu items “LrS” is used to reset the Learning
Algorithm matrix.
Go to the menu list, navigate to item “LrS” by Pressing the UP and DOWN buttons. Press the
ENTER button to enter the value.
The displayed value will be “0”, Change to “1” (where 0 = No & 1 = Yes) with either the UP or
DOWN buttons. Press the ENTER button to confirm.
7.1.1.4
PARAMETERS RESET
Parameter Reset is needed to reset all parameters back to the default (factory-set) value. Menu items
“PrS” is used to reset the parameters settings
Go to the menu list, navigate to item “PrS” by Pressing the UP and DOWN buttons. Press the
ENTER button to enter the value.
The displayed value will be “0”, Change to “1” (where 0 = No & 1 = Yes) with either the UP or
DOWN buttons. Press the ENTER button to confirm.
Page 19
SOLL AT EK
INTELLIGENT CONTROL S