2. Drill holes in points where you wish to install the
alarm. Use rear cover as template.
3. Use screws and dowels attached to the product
package; do not apply excessive force while
tightening the screws. Use more suitable fastening
material when necessary.
4. Insert two AAA alkaline batteries. Mind the indicated
polarity.
5. Attach the detector to the rear cover and rotate it
clockwise to fix it.
Functional test
The detector is equipped with a diagnostic circuit, testing the sensor’s and siren’s function every ten
seconds. However, we recommend you to test the device for function every month. You can do it
as follows.
Push the TEST/HUSH button shortly. Afterwards, you will hear the alarm signal and the LED diode
(alarm) will flash 4 times in four series in a row. This indicates correct function.
Alarm mode
If harmful CO concentration is detected, the detector will switch to constant alarm mode. In such
case, immediately proceed as follows:
1. Provide ventilation in the room affected and leave the room. If no ventilation is possible,
immediately leave to fresh air or to another ventilated room with lower or no CO concentration
at all.
2. If there is anybody inside the affected room experiencing carbon monoxide poisoning
symptoms described above, immediately call the ambulance and the fire brigade. All persons
and animals must be immediately evacuated. Count all the present persons and animals to
make sure nobody is forgotten.
3. Do not re-enter the affected rooms until the problem has been resolved and until carbon
monoxide has diffused. Its concentration must sink to a safe level. The alarm will automatically
stop signalling dangerous CO concentration when it drops to a safe level.
Alarm activation values:
CO level
Reaction time
Type of audible alarm
30
– 49PPM
After 120 minutes
2x sound signal at a frequency of 1s
50
– 99PPM
After 60
– 90 minutes
3x sound signal at a frequency of 1s
100
– 299PPM
After 10
– 40 minutes
4x sound signal at a frequency of 1s
300PPM or more
Up to three minutes
4x sound signal at a frequency of 0.5s
Silent alarm mode
Solight 1D36 detector also has a silent alarm function If the detector triggers the alarm, it can be
put on silent mode by pushing the TEST/HUST button. In this mode, the red (Alarm) diode will flash
once simultaneously with the green (Power) diode every ten seconds for two minutes. If the
concentration of carbon monoxide exceeds 300PPM within three minutes, the loud alarm will be
trigged again. If the concentration drops below 5PPM (included), the alarm signal will stop.
If you wish to exit the silent alarm mode, push the TEST/HUSH button repeatedly.
Backward warning function
Rear cover (bracket)
Tighten
Release
