ASSEMBLY & INSTALLATION (CONT.)
Weather Insulation Board Installation
NOTE:
The Weather Installation Board adds an extra layer of
insulation to keep air from passing through the sides of the win-
dow air conditioner.
1. Using a sharp blade or scissors, slowly cut the
Weather Insulation Board to a size that will fit inside of
the side curtain rails and completely cover the curtain.
2. Once properly sized, remove the backing to expose
the adhesive tape.
3. Place the Weather Insulation Board over the left curtain
and firmly press and hold for 5 seconds.
4. Place the Weather Insulation Board over the right cur-
tain and firmly press and hold for 5 seconds (FIG. 7.1).
F
ig
.
7.1
Placing the Cabinet Inside the Window
1. Attach the top mounting rail to the unit with short
screws (See Fig.8).
1. Open the window and place the cabinet in the middle
of the window sill.
2. Make sure the bottom rail is seated over the window-
sill as shown below. Bring the window down tempo-
rarily behind the top mounting rail to hold the cabinet
in place.
2. Slide the free end of the curtain into the side panel of
the air conditioner. Do this for each side. The flange
for securing the curtain into the window sill will be fac-
ing the room side when installed (See Fig.9).
3. Fasten the curtains to the unit with short screws (See
Fig.10)
3. Fasten cabinet to window sill using three long screws.
Pre-drill holes if needed. Add the bottom rail seal over
the screws (See Fig.11).
Curtain Installation
Weather Insulation
Board
Curtain
Curtain
F
ig
.
8
F
ig
.
9
F
ig
.
10
F
ig
.
11
9
Top Mounting Rail
Long Screw
Bottom Rail Seal
