10
USING YOUR AIR CONDITIONER
(Cont.)
•
Freezing Conditions:
This is a cooling only air
conditioner. It is not designed for freezing outdoor
conditions. It must not be used in freezing outdoor
conditions.
•
Remote Control:
To ensure proper operation
when using the remote control, aim the remote
directly at the signal receiver on the air condi-
tioner.
•
The remote control has a signal range up to
20 feet.
•
Make sure nothing is blocking the remote con-
trol signal from being received by the air con-
ditioner.
•
Make sure the batteries are installed correctly
and still have power.
•
Cooling Mode:
Use the COOL mode at Low, Me-
dium, High, or Auto Fan speed when cooling is
needed. Use the temperature
▲
/
▼
buttons to set
the desired temperature between 64°F and 86°F.
•
Once the temperature is set, the compressor
will cycle on and off to keep the room
temperature at the set temperature level. The
lower the set thermostat temperature, the
cooler the room will become. The higher the
set thermostat temperature, the warmer the
room will become.
•
For Normal Cooling - Set the Mode to
Cool
and the Fan to
High
or
Med
with the
termperature set in the middle.
•
For Maximum Cooling - Set the Mode to
Cool
and the Fan to
High
with a lower set
temperature.
•
For Quieter & Nighttime Cooling - Set the
Mode to
Cool
and the Fan to
Low
with the
temperature set in the middle.
NOTE:
If the air conditioner is off and is then
turned on while set to a Cool setting or if
turned from a fan setting to a Cool setting, it
may take approximately 3 minutes for the
compressor to start and cooling to begin.
•
Energy Saver Mode
- Controls the Fan
On
- The fan will cycle on and off with the
compressor. This results in winder variations of room
temperature and humidity. Normally used with the
room is unoccupied. NOTE: The fan my continue to
run for a short time after the compressor cycles off.
Off
- The fan runs all the time in fan or cooling mode.
•
Fan Only Mode:
Use
Fan Only
mode at
Low
,
Med
, or
High
fan speed to provide air circulation
and filtering without cooling. Since fan only setting
do not provide cooling, a
Set
temperature cannot
be entered. The room temperature will appear in
the display.
NOTE:
Auto Fan
Speed cannot be used in
Fan
Only
mode.
•
Loss of Power Protection:
If power to the air
conditioner is lost or interrupted, the air condi-
tioner will automatically re-start in the setting last
used prior to power loss. If the Timer was set to
automatically turn the air conditioner off or on, it
will resume countdown at the amount time left
prior to power loss. You may need to set a new
time if desired.
•
Air Direction:
Use the lever on the front air vents
to adjust the direction of the airflow. You can di-
rect the airflow left, right, up or down. The lever is
located on the right side of the air vent.
