Soleus Air SG-TTW-10ESE, Руководство по установке

Страница: 5 / 16

6
Standard Wall Sleeve
4 1/2"
4
1. Remove the outside enclosure panel from the wallsleeve.
2. Slide the wall sleeve into the wall opening. Do not distort the cabinet shape to
fit the wall opening; the unit chassis must fit snugly and uniformly into the wall sleeve.
3. Locate the sleeve within the range of minimum projections, so both sides are at least
the minimum projection from the wall.
4. Check the level of the wall sleeve. For proper drainage, the sleeve should be level from
side to side and one-quarter bubble front to back (outside).
5. Drill two holes in both sides of the wall sleeve so mounting screws can be secured
to wall supports. DO NOT DRILL THROUGH BOTTOM OF SLEEVE.
6. Check the level of the wall sleeve and adjust if necessary.
7. Caulk or seal around the outside of the entire sleeve.
8. If the unit chassis is not to be installed immediately, replace the enclosure panel on the
outside opening of the sleeve to limit weather damage to the building interior.
9. Recycle or dispose of packaging materials according to local codes.
www.sylvane.com 1-800-934-9194