Soleus Air SG-PTAC-09HPDA, Руководство пользователя

Страница: 12 / 20

HOW TO CONNECT
IMPORTANT: Please read following electrical safety data carefully.
!
WARNING
ELECTRICAL SHOCK AND/OR UNIT OPERATION AND DAMAGE HAZARD
Failure to follow this warning could result in personal injury or death and/or unit operation and damage.
S Follow the National Electrical Code (NEC) or local codes and ordinances.
S For personal safety, this unit
MUST BE
properly grounded.
S Protective devices (fuses or circuit breakers) acceptable for unit installations are specified on the nameplate of each unit.
S Do not use an extension cord with this unit.
S Aluminum building wiring may present special problems -- consult a qualified electrician.
S When unit is in STOP position, there is still voltage to electrical controls.
S Disconnect power to unit before servicing by:
1. Removing power cord (if it has one) from wall receptacle.
2. Removing branch circuit fuses or turning circuit breakers off at panel.
1. Remove front panel. See Fig. 11.
2. Remove junction box.
S
Remove junction box cover by removing three screws from front. Remove junction box by taking
out top, rear and side screws. See Fig. 14.
3. Connect accessory power supply cord or hard wire connector to unit connector. See Fig. 15.
S
Units must be installed using the appropriate power supply kit. See Table 4 -- POWER CONNECTION
CHART. These connections must be followed.
4. Reinstall junction box and cover.
S
Use wire clamp to attach power cord to basepan. Secure with screws (included) See Fig. 16.
S
Relace junction box and cover with screws removed from Step 2. Tighten securely.
5. Replace front panel. See Fig. 13.
6. Connect power to unit.
Unit connector
Junction box cover Junction box
Fig. 14 – Junction Box Location
Accessory
Power Supply Cord
or Hard Wire
Fig. 15 – Power Connection
Wire clamp
Fig. 16 – Wire Clamp
Table 4—POWER CONNECTION CHART
30A 20A 15A
SG-PTAC-09HDP A
NA*
SG-PTAC-12HDP A
SG-PTAC-15HDP A
UNIT MODEL
* Using 30A on these units could result in damage to your unit.
PWRCORD-
230V-30A
230/208 VOLT
PWRCORD-
230V-30A
PWRCORD-
230V-30A
CODE OF POWER SUPPLY KIT
10