SOLE ALPHA 3 Скачать руководство пользователя страница 5

Страница: 5 / 8

1.4. Carefully lower the product so that the support frames touch the ground (photo 3) and provided
this is the most suitable place (no obstacles etc.) secure it to the ground with 4 raw-plugs through
the holes on the base of the support frames.

Photo 3

2. PLUMBING CONNECTION

2.1. A pipe with a blue rubber ring is situated at point C (photo 2). This is the cold water supply inlet.
Screw the safety valve on this pipe, and then connect the cold water mains. The safety valve can
be found in the small package containing screws etc. accompanying the product.
However in the case where a water supply mains with pressure does not exist and water is supplied
through a water tank which is situated a little higher than the product, do not use the safety valve.
The safety valve requires at least 1 bar pressure in order to allow the water to pass through. A gate
valve should also be connected to the cold water pipe so that the water supply can be shut off when
necessary.

2.2. A pipe with a red rubber ring is situated at point B (photo 2). This pipe is the hot water outlet.
Connect this pipe to the hot water distribution network for consumption.

3. WARNING

The hot water pipe must be well insulated in order to prevent the reduction in temperature before
the water reaching consumption. If the ambient temperature of your area reaches temperatures
lower than 0°C, it is necessary to insulate the cold water pipe as well, in order to prevent it from
freezing and breaking.
This product has been manufactured to withstand up to -15°C for 2 consecutive days. In case we
have such conditions for more consecutive days, a hot water tap must be left open and some water
must run through it continuously to avoid any damage or switch on the electric heating element for 1
hour per day/night.