Dyaco Canada Inc. 2013 [email protected]
11
4
SEAT/PEDAL &
PLASTIC PARTS
HARDWARE
STEP 4
1.
Install the Seat (
61
) on the Seat Carriage (
4
) with the four Phillips
Head Screws (
98
) using the Phillips Head Screw Driver (
114
).
These
are the biggest screws included in the package for this step.
2.
Install the Front Stabilizer Cover (
32
) and the Rear Stabilizer Cover
(
37
) on the Main Frame (
1
) with four Phillips Head Screws (
99
) using
the Phillips Head Screw Driver(
114
).
3.
Plug in the Computer Cable (
44
) and Hand pulse Cable (
45
) into the
connector in the back of the Console Assembly (
19
). Install the
console onto the mounting plate with four Phillips Head Screws (
99
)
using the Phillips Head Screw Driver (
114
). Be careful not to pinch
the cables between the console and the mounting plate. This could
short the cables and damage the electronics.
4.
Install the Drink Bottle Holders (
39
L,
38
R) onto left and right sides of
the Seat Handle Bar (6
)
with four Sheet Metal Screws (
105
) using the
Phillips Head Screw Driver(
114
).
5.
Install the Pedals (
116
L,
117
R) in the Pedal Cranks using the
14/15mm Wrench (
132
). Keep in mind that the Pedal (
116
L) has a
reverse thread and will be screwed into the crank in the opposite
rotational pattern right hand threads. There is an “L” stamped into the
end of the threaded post of the left pedal and an “R” in the right. Make
sure to tighten the pedals as firmly as you possibly can. It may be
necessary to re-tighten the pedals if you notice a thumping sound
when pedaling the bike. A clicking noise, or thumping sound during
pedaling is usually caused by the pedals being loose.
#98
. M6 x 15mm Phillips
Head Screw (4 pcs)
#99
. M5 x 12mm Phillips
Head Screw (8 pcs)
#105
. Ø4 x 16mm Sheet
Metal Screw (4 pcs)
