Dyaco Canada Inc. 2013
25
GENERAL
MAINTENANCE
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of
two reasons:
I. The hardware was not sufficiently tightened during assembly. All bolts that were
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the
bolts sufficiently. I cannot stress this point enough; 90% of calls to the service
department for noise issues can be traced to loose hardware or the rear rails being
dirty.
II. Dirt build-up on the rear rails and polyurethane wheels are also a source of noise.
from build-up on the rails can cause a thumping sound that you would swear is
coming from inside the main body of the machine because noise travels, and is
amplified in the tubing of the frame. Clean the rails and wheels with a lint free cloth
and rubbing alcohol. Stubborn build-up can be removed with your thumbnail or a
non-metallic scraper, like the back edge of a plastic knife. After cleaning, apply a
small amount of lubricant on the rails with your fingers or a lint free cloth. You only
need a thin coat of lubrication, wipe off any excess.
3. If squeaks or other noises persist, check that the unit is properly leveled before calling the
service department.
MAINTENANCE MENU IN CONSOLE SOFTWARE
The console has built in maintenance/diagnostic software. The software will allow you to
change the console settings from English to Metric and turn off the beeping of the
speaker when a key is pressed for example. To enter the Maintenance Menu (may be
called Engineering Mode, depending on version) press and hold down the
Start
,
Stop
and
Enter
keys keep holding the keys down for about 5 seconds and the
Message
Window
will display “Engineering Mode”. Press the
Enter
button to access the menu
below. Press the
Level
▲
/
▼
keys to navigate the menu.
A.
Key Test
- Will allow you to test all the keys to make sure they are functioning
B.
Display Test
- Automatically tests all LCD’s
C.
Functions
- Press
Enter
to access settings, use
Level
▲
/
▼
keys to scroll
I.
ODO Reset
- Resets the odometer
II.
Units
- Choose from English or Metric display readings
III.
Display Mode
- Turn off to have the console power down automatically after 30
minutes of inactivity
IV.
Motor Test
- Continually runs the tensioning gear motor
V.
Manual
- Allows stepping of the gear motor
VI.
Pause Mode
- Turn on to allow 5 minutes of pause, turn off to have console pause
indefinitely
VII.
Key Tone
- Turn on or off the beep sound when a key is pressed
D.
Security -
Allows you to lock the keypad so no unauthorized use of the machine is
allowed. When the child lock is enabled, the console will not allow the keypad to operate
unless you press and hold the
Start
and
Enter
buttons for 3 seconds to unlock the
console.
E.
Factory Set
F.
Exit
- Select to exit Maintenance Menu
Incline Calibration:
If there is a problem with the incline, try running the calibration.
Press the
Incline up
key and the
Start
key at the same time. Hold them down for 5
seconds and the Incline calibration will start and run automatically. If the problem persists
contact service department.
